Brakes

Posted by admin November 17th, 2008

Upgrading the front drum brakes to disc and installing a dual master cylinder and booster. The booster will be powered by an electric vacuum pump.

The front drum brakes were converted to disc brakes for added stopping power. This was easily done with a conversion kit.

The rear brakes are the original Corvair drum brakes.

An emergency brake handle was found at the junk yard that works perfectly. I fabricated a peice of steel plate which bolts to the frame to hold the brake.

The emergency brake uses two cables which come off of the brake handle and go to the back brakes.

The local U-Pull-It junkyard is a great source for parts. In this case, I found an older model Camero with a perfect dual master cylinder and proportioning valve system for the car.

A special mount had to be made to mount the cylinder so it would angle slightly to miss the nostrels and also align with the brake pedals properly.

Here the plumbing for the breaks has been installed. The local NAPA autoparts store was terrific in helping me with this part. My thanks to the guys there. They supplied me with a special kit which included a special tubing that was bendable by hand but rated for high pressure brake lines. This saved a lot of time and was a lot easier that bending steel tubing. The kit also came with all the fittings.


Newer :

Older :

One Response

  1. faridmi says:

    hello
    may I ask how did you chose your vacuum pump?
    thanks for your nice blog